Request Information
The Lewis Snake Grip (LSG) expands or contracts to grip different or identical cable and/or wire rope sizes as needed.

The swivel and swing link go smoothly through blocks and prevent line twisting. Install new cable by using old existing cable as pulling line. Always seize the ends of the grips by banding and taping. Make sure to BAND AND TAPE the ends of the grips.

Rotating with Removable Link-STANDARD PROFILE.
Unit of Measure

Specifications

Brand

 N/A Lewis

Type

 N/A Wire Rope & Cable Snake Grip

Work Load (WL)

 N/A 3500 lb

Ultimate Tensile Strength (UTS)

 N/A 7000 lb

Style

 N/A LSG Snake Grip

Dimensions

Range

 N/A 1 to 2 in

Additional Information

Additional Information

 N/A The swivel and swing link go smoothly through blocks and prevent line twisting. Install new cable by using old existing cable as pulling line. Always seize the ends of the Grip by banding and taping. Make sure to BAND AND TAPE the ends of the Grips.

Warning

Warning

 N/A READ THIS GUIDELINE BEFORE USING LSG SNAKE GRIPS
FOLLOW GRIPS BANDING INSTRUCTIONS CONTAINED IN THIS DOCUMENT
  1. Safety is always No. 1. Make sure no one is under the line as it is being pulled through the blocks and crown.
    DO NOT stand below or near the drilling line under tension, severe injury or death could occur. KEEP BACK
  2. Both ends of the snake grip must be properly BANDED AND TAPED according to banding instructions located in this document
  3. Failure to follow the safety and use instructions properly could lead to injury or even death.

Note

Note

 N/A The Grip on the Special Size LSG models are not the same on each side.