• Socket Type End Bells
  • Box Connectors

    A box connector creates a separable termination into a box. This connector has straight threads (NPS) and is supplied with a locknut.

  • Box Connectors with Gasket

    A box connector creates a separable termination into a box. This connector has straight threads (NPS) and is supplied with a locknut.

  • Male Adapters

    Male adapters with tapered threads (NPT) are generally used for joining to female threads of rigid steel, Myers type hubs or terminating into precast iron boxes with female thread entrances.

  • Male Adapters with Gasket

    Male adapters with tapered threads (NPT) are generally used for joining to female threads of rigid steel, Myers type hubs or terminating into precast iron boxes with female thread entrances.

  • Female Terminal Adapters

    This adapter is generally used for joining fiberglass conduit with galvanized rigid steel (GRS) conduit. It has the same threads as GRS conduit and can easily be attached to GRS conduit.

  • Sleeve Couplings
  • Sleeve Couplings with Gasket
  • Stop Couplings

    Stop coupling is sometimes referred to as a double bell coupling.

  • Stop Couplings with Gasket

    Stop coupling is sometimes referred to as a double bell coupling.

  • Socket x Spigot Single Expansion Joints with O-Ring
  • Socket x Socket Single Expansion Joints with O-Ring
  • Alignment/Expansion Fittings with O-Rings

    Alignment/Expansion fitting is sometimes referred to as an Expansion/Deflection joint.
    (The clamps holding the rubber sleeve connecting the two nipples are made from stainless steel for corrosion protection.)

  • Fiberglass End Caps with Gasket
  • Socket Type End Bells

    End bells are used for creating a permanent termination into a box as well as having a smooth surface that the cable can be pulled over.

  • Split Anchor Rings

    Split anchor rings are always supplied in pairs and are used for above ground installations in order to create fixed points. The split anchor rings are placed around the hanger closest to the mid point between two expansion joints. One pair of split anchor rings is placed on each side of the hanger. The split anchor rings are bonded with epoxy adhesive to the outside of the conduit. The hanger where split anchor rings are used is called an anchor hanger and is normally braced.

  • Thermoplastic Plugs
  • Reducing Adapters

    This adapter is used for transition between different diameters of fiberglass conduit.

  • Wobble Couplings

    Wobble couplings are used for minor vertical and horizontal offsets for above ground installations. (Item numbers for wobble couplings end with the suffix - 48.)