Part No. LSG 1-1 1/2-PSO, 1 to 1 1/2 in. Range LSG-PSO Series Wire Rope and Cable Snake Grip On Colonial Teltek

Request Information

The Lewis Snake Grip (LSG) expands or contracts to grip different or identical cable and/or wire rope sizes as needed.

The swivel and swing link go smoothly through blocks and prevent line twisting. Install new cable by using old existing cable as pulling line. Always seize the ends of the grips by banding and taping. Make sure to BAND AND TAPE the ends of the grips.

LSG Snake without the Link

Unit of Measure

Specifications | Dimensions | Additional Information | Warning

Specifications

Brand	N/A Lewis
Type	N/A Wire Rope & Cable Snake Grip
Work Load (WL)	N/A 3500 lb
Ultimate Tensile Strength (UTS)	N/A 7000 lb
Style	N/A LSG-PSO Snake Grip Half

Dimensions

Range

N/A 1 to 1 1/2 in

Additional Information

N/A You can also order LSG Snake Grips by themselves without the link. Just add PSO to the end of the LSG model no.

Make sure to BAND AND TAPE the ends of the Grip.

Warning

N/A READ THIS GUIDELINE BEFORE USING LSG SNAKE GRIPS
FOLLOW GRIPS BANDING INSTRUCTIONS CONTAINED IN THIS DOCUMENT

Safety is always No. 1. Make sure no one is under the line as it is being pulled through the blocks and crown.
DO NOT stand below or near the drilling line under tension, severe injury or death could occur. KEEP BACK
Both ends of the snake grip must be properly BANDED AND TAPED according to banding instructions located in this document
Failure to follow the safety and use instructions properly could lead to injury or even death.