Tapered buttress threads thread into the innerduct for maximum pulling strength. These eyes connect directly to a Condux swivel. When properly sized and installed, these eyes will not pull out of the innerduct until the pulling tensions have greatly exceeded the maximum pulling tensions recommended by the innerduct manufacturers.
NOTE: To determine correct pulling eye size, obtain the actual innerduct inside diameter (I.D.). The I.D. measurement must be greater than dimension A and smaller than dimension B.
NOTE: To determine correct pulling eye size, obtain the actual innerduct inside diameter (I.D.). The I.D. measurement must be greater than dimension A and smaller than dimension B.
Unit of Measure
Specifications
Nominal Size (in.) |
N/A 2 |
Nominal Size (mm) |
N/A 51 |
Innerduct I.D. Range A to B (in.) |
N/A 2.06 to 2.18 |
Innerduct I.D. Range A to B (mm) |
N/A 52 to 56 |
Max. O.D. C (in.) |
N/A 2.50 |
Max. O.D. C (mm) |
N/A 64 |
Hole Diameter D (in.) |
N/A 0.38 |
Hole Diameter D (mm) |
N/A 10 |
Eye Diameter E (in.) |
N/A 0.63 |
Eye Diameter E (mm) |
N/A 16 |
Eye Diameter F (in.) |
N/A 0.25 |
Eye Diameter F (mm) |
N/A 6 |
