Colonial TelTek
Colonial TelTek
201 W. Church Road
King of Prussia, PA 19406
Phone: (855) 686-7713
Email: Info@colonialteltek.com
Website: www.knobsource.com
Print Back
The Lewis Snake Grip (LSG) expands or contracts to grip different or identical cable and/or wire rope sizes as needed.

The swivel and swing link go smoothly through blocks and prevent line twisting. Install new cable by using old existing cable as pulling line. Always seize the ends of the grips by banding and taping. Make sure to BAND AND TAPE the ends of the grips.

LSG Snake without the Link
Unit of Measure

Specifications

Brand

 N/A Lewis

Type

 N/A Wire Rope & Cable Snake Grip

Work Load (WL)

 N/A 4000 lb

Ultimate Tensile Strength (UTS)

 N/A 8000 lb

Style

 N/A LSG-PSO Snake Grip Half

Dimensions

Range

 N/A 1 1/2 to 2 in

Additional Information

Additional Information

 N/A You can also order LSG Snake Grips by themselves without the link. Just add PSO to the end of the LSG model no.

Make sure to BAND AND TAPE the ends of the Grip.

Warning

Warning

 N/A READ THIS GUIDELINE BEFORE USING LSG SNAKE GRIPS
FOLLOW GRIPS BANDING INSTRUCTIONS CONTAINED IN THIS DOCUMENT
  1. Safety is always No. 1. Make sure no one is under the line as it is being pulled through the blocks and crown.
    DO NOT stand below or near the drilling line under tension, severe injury or death could occur. KEEP BACK
  2. Both ends of the snake grip must be properly BANDED AND TAPED according to banding instructions located in this document
  3. Failure to follow the safety and use instructions properly could lead to injury or even death.