Colonial TelTek
Colonial TelTek
201 W. Church Road
King of Prussia, PA 19406
Phone: (855) 686-7713
Email: Info@colonialteltek.com
Website: www.knobsource.com
Print Back
Tapered buttress threads thread into the innerduct for maximum pulling strength. These eyes connect directly to a Condux swivel. When properly sized and installed, these eyes will not pull out of the innerduct until the pulling tensions have greatly exceeded the maximum pulling tensions recommended by the innerduct manufacturers.

NOTE: To determine correct pulling eye size, obtain the actual innerduct inside diameter (I.D.). The I.D. measurement must be greater than dimension A and smaller than dimension B.
Unit of Measure

Specifications

Nominal Size (in.)

 N/A 1

Nominal Size (mm)

 N/A 25

Innerduct I.D. Range A to B (in.)

 N/A 0.93 to 1.06

Innerduct I.D. Range A to B (mm)

 N/A 24 to 27

Max. O.D. C (in.)

 N/A 1.22

Max. O.D. C (mm)

 N/A 31

Hole Diameter D (in.)

 N/A 0.25

Hole Diameter D (mm)

 N/A 6

Eye Diameter E (in.)

 N/A 0.50

Eye Diameter E (mm)

 N/A 13

Eye Diameter F (in.)

 N/A 0.25

Eye Diameter F (mm)

 N/A 6