Print Back
Tapered buttress threads thread into the innerduct for maximum pulling strength. These eyes connect directly to a Condux swivel. When properly sized and installed, these eyes will not pull out of the innerduct until the pulling tensions have greatly exceeded the maximum pulling tensions recommended by the innerduct manufacturers.

NOTE: To determine correct pulling eye size, obtain the actual innerduct inside diameter (I.D.). The I.D. measurement must be greater than dimension A and smaller than dimension B.
Fixed Head Innerduct Pulling Eyes
Fixed Head Innerduct Pulling Eyes-2
Unit of Measure
Items Fixed Head Innerduct Pulling Eyes
08913318
Fixed Head Innerduct Pulling Eyes
Fixed Head Innerduct Pulling Eyes
08913319
Fixed Head Innerduct Pulling Eyes
Fixed Head Innerduct Pulling Eyes
08913320
Fixed Head Innerduct Pulling Eyes
Fixed Head Innerduct Pulling Eyes
08913321
Fixed Head Innerduct Pulling Eyes
Fixed Head Innerduct Pulling Eyes
08913325
Fixed Head Innerduct Pulling Eyes
Nominal Size (in.) N/A 3/4 N/A 7/8 N/A 1 N/A 1-1/4 N/A 1-1/4
Nominal Size (mm) N/A 19 N/A 22 N/A 25 N/A 32 N/A 32
Innerduct I.D. Range A to B (in.) N/A 0.68 to 0.81 N/A 0.81 to 0.93 N/A 0.93 to 1.06 N/A 1.06 to 1.18 N/A 1.18 to 1.34
Innerduct I.D. Range A to B (mm) N/A 17 to 21 N/A 21 to 24 N/A 24 to 27 N/A 27 to 30 N/A 30 to 34
Max. O.D. C (in.) N/A 1.13 N/A 1.25 N/A 1.22 N/A 1.50 N/A 1.50
Max. O.D. C (mm) N/A 29 N/A 32 N/A 31 N/A 38 N/A 38
Hole Diameter D (in.) N/A 0.25 N/A 0.25 N/A 0.25 N/A 0.38 N/A 0.38
Hole Diameter D (mm) N/A 6 N/A 6 N/A 6 N/A 10 N/A 10
Eye Diameter E (in.) N/A 0.50 N/A 0.50 N/A 0.50 N/A 0.63 N/A 0.63
Eye Diameter E (mm) N/A 13 N/A 13 N/A 13 N/A 16 N/A 16
Eye Diameter F (in.) N/A 0.25
Eye Diameter F (mm) N/A 6