The CHAMPION MIX® system is a two part adhesive, epoxy resin system, designed to permanently bond fittings and joints of fiberglass reinforced epoxy conduit. It is also designed for use with pultruded polyester and vinyl ester components. Each cartridge system contains resin, hardener, and one plastic static mixer. An adhesive gun is required for applying the adhesive (ordered separately).

Under normal conditions, it takes approximately 45 minutes for the CM-2040 and CM-2070 adhesives to harden at their rated temperatures. If a faster setting adhesive is desired, there are CHAMPION MIX® adhesives available that gel much faster.
Unit of Measure

Specifications

Brand

N/A Champion Fiberglass®, Inc.

Type

N/A Epoxy Adhesive

Temperature Range

N/A 21 and up ºC70 and up ºF

Approximate Curing Time

N/A 20 to 30 Minutes

Product Form

N/A Gel

Estimated Number of Joints Per Container

Estimated Number of Joints per Container (3/4 in.)

N/A 100

Estimated Number of Joints for Container (1 in.)

N/A 85

Estimated Number of Joints per Container (1 1/4 in.)

N/A 75

Estimated Number of Joints per Container (1 1/2 in.)

N/A 60

Estimated Number of Joints per Container (2 in.)

N/A 50

Estimated Number of Joints per Container (2 1/2 in.)

N/A 40

Estimated Number of Joints per Container (3 in.)

N/A 35

Estimated Number of Joints per Container (3 1/2 in.)

N/A 30

Estimated Number of Joints per Container (4 in.)

N/A 25

Estimated Number of Joints per Container (5 in.)

N/A 20

Estimated Number of Joints per Container (6 in.)

N/A 15

Note for Estimated Number of Joints Per Container

N/A Estimated only, as it varies depending on the amount of adhesive applied per application.

Application

Application

N/A Permanently bond fittings and joints of fiberglass reinforced epoxy conduit.
Use with pultruded polyester and vinyl ester components.

General Information

General Information

N/A The "Fast Gel" adhesives can be specified by adding the suffixes, "FG" or "SFG" to the part numbers. Because the "Fast Gel" and "Super-Fast Gel" adhesives set up quicker, additional mixing tubes may be required.

Note

Note

N/A Proper mixing can be visually ascertained when the epoxy mixture is evenly gray.