• Tapered Heads

    Attaches to the end fitting on the duct rod. Guides duct rod through the conduit and allows a pull line (diameter A) to be attached to the duct rod. Comes standard with each of the duct rodders.

  • Fiberglass Hand Rods

    Screw together fiberglass duct rods for straight runs. All rods equipped with 3/4"-10 end fittings, which work with 3/4"-10 duct rodder accessories. 2,500 lb. (11,120 N) pull rating.

  • Replacement Brass Hand Rod End Fittings

    Requires Epoxy: 08035851

  • Mud Scoops

    Attaches to the end of the hand rods and is used to clear the conduit of mud. The mud scoop is pushed into the conduit, it fills with mud, and is then pulled back out and cleaned. This process is repeated until the conduit is cleaned of mud. Works in 4" (102 mm) or larger conduit only. Does not negotiate tight bends.

  • Basket Combinations

    Used to connect two hand rods pushed into the conduit from opposite ends of the conduit run. Both rods can then be pulled out in one direction. Used instead of a swivel coupling when the full length of the rod is difficult to push from one end. Works in 4" (102 mm) or larger conduit only. Does not negotiate tight bends.